|
Air Flex/Pro Tac Tutorial
Step#1 Apply to freshly shampooed hair, free of any oil or conditoner. You can condition the lower half of the hair. Part a section of your hair and secure the rest with hair clamps.
Step#2 Place Pro tac strip on top of the hair and measure length of the strip needed and cut.
Step#3 Place the hair weft over the Pro tac strip and measure a section of hair needed and cut.
Step#4 Pull off the bottom half of the white strip.
Step#5 Firmly press hair down attaching it to the strip.
Step#6 Pull off top white half of the strip and fold over sandwiching the hair in between.
Step#7 Using a flat iron on a medium setting, heat against the weft to set the Pro tac strip (approx. 5 seconds).
Step #8 Pull the blue backing material off and carefully hold each end with fingertips. Do not throw away the blue backing.
Step#9 Press firmly in place across the parted sectioned hair.
Step#10 The exposed tape is sticky. So take the blue backing from the tape and press it over the installed Protac wefts. This will allow you to press firmly without the adhesive tape sticking to your fingers.
Step#11 Part a section of the hair just above the installation. Now take small sections of the parted hair and slowly place over the top of the strip. Make sure to place the hair straight down rather than just letting it fall down over the top of the strip. Press down firmly attaching it to the top of the strip.
Add as many rows as you like for a full head installation to add length, or just a few rows to add volume or highlights.
| 
